All screw piles are delivered hot-dip galvanised (zinc layer thickness about 80 µm).

A variety of fasteners are available for screw piles, such as U-shoes, cap plates, bolt fixtures and pile caps. U-shoes,bolt mounts, and flat steel are well suited for fixing timber to screw piles.When the screw pile is left in the concreting, pile caps should be used overthe piles. It is also possible to weld steel beams onto the screw piles, on topof which e.g. a composite slab or hollow-core sl...

Normally, the pile pipe does not need to befilled with concrete after installation, but if the water table is closer than1 m from the ground surface, it is recommended that the pile pipe be filledwith grouting, urethane foam, or sand. Filling the pile pipe with concretemight also improve the pile’s resistance to buckling and avoid one-sided pilepipe corrosion.

The helix of the screw pile should beinstalled at least below the frost line. This ensures that the foundations willnot be susceptible to frost movements.The installation depth is also determinedby the soil at the place of installation, together with the desired loadcapacity and lateral support.

The most favourable soils for screw piles are clay and sandy soils. Owing to the large surface area of the helix, a screw pile has a better carrying capacity than standard steel piles. The good carrying capacity means that adequate capacity is attainable even in layers of clay or sand. Screw piles do not often need to be installed as deep as in piledriving, and thus both the length and costs of th...

Due to we could provide all kinds of sizes products,so both small and large construction projects can use screw pile instead of concrete foundations. Small-scale applications are terraces,fences, canopies, garden buildings, piers and landing stages, etc. For small buildings, the foundations can use hand-installable screw piles, which can beeasily installed with a crowbar or other bar. Large-scale ...